Rayne 3D Prints Shop on Etsy

In the shop

iPhone in StandBy clock mode on the Highland MagSafe mount

Tesla Model 3 Highland MagSafe mount

$14.99 Free shipping

A factory-looking home for your iPhone, right where the gauge cluster would be. It grips the dash trim without tools or adhesive, holds an official Apple MagSafe puck, and routes the cable underneath so nothing dangles.

  • FitsTesla Model 3 Highland, 2024 and newer
  • PhonesiPhone 12 and newer with MagSafe
  • MaterialASA. Heat and UV resistant, will not warp in a hot car
  • InstallTool free, no adhesive, seconds
  • IncludesMount only. Bring your own Apple MagSafe charger
  • DesignBy windo.ac, sold with permission
Buy on Etsy

Free shipping. Returns and exchanges accepted within 30 days.

A slim Celsius can held upright in a Tesla Model Y cup holder by the insert

Tesla Model Y slim can holder

$12.99 Free shipping

Tesla's cup holders were sized for a 16 oz bottle, so a skinny can tips and rattles on every corner. This insert drops into the console and gives 12 oz slim cans a snug, upright seat. Pops out just as easily.

  • FitsTesla Model Y and Model 3 center console cup holders
  • CansCelsius, Red Bull, White Claw, Truly, most 12 oz slim cans
  • MaterialABS. Heat resistant, safe in a parked car in summer
  • ProfileLow and lightweight, does not crowd the console
Buy on Etsy

Free shipping. Returns and exchanges accepted within 30 days.

Three Sony NP-SA100 batteries seated in the black four slot holder

Sony FX5 battery holder

$15.99 Free shipping

A snug four slot home for the new Sony NP-SA100, the battery that ships with the FX5 and the a7R VI. Each pack slides in end-first and a low front lip lets it slide back out with a finger. Contacts out means charged, contacts in means dead, so you can read the row at a glance.

  • FitsSony NP-SA100 only. Will not fit the older NP-FZ100
  • CamerasSony FX5, Sony a7R VI
  • Holds4 batteries, light friction fit, each pack in its own slot
  • MaterialPETG, matte black
  • IncludesHolder only. Batteries not included
  • DesignBased on Rod Laird's NP-FZ100 holder (CC BY), used with permission
Buy on Etsy

Free shipping. Returns and exchanges accepted within 30 days.

The belt clip worn on a belt at the hip

Sony NP-FZ100 battery belt clip

$12.99 Free shipping

A spare battery rides on your belt instead of in a pocket, so the swap takes seconds. The battery drops in from the top, stays put while you move, and comes out with one thumb.

  • FitsSony NP-FZ100 batteries
  • Camerasa7 IV, a7 III, a7S III, a7R V, a7R IV, a1, a9 II, FX3, FX30, ZV-E1, a6600, a6700
  • Holds1 battery, light friction fit, open sides keep the contacts clear
  • MaterialASA, matte black
  • IncludesClip only. Battery not included
Buy on Etsy

Free shipping. Returns and exchanges accepted within 30 days.